Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a bit but it's still eye-catching. It's not the most luxurious car in its class, but it is a pleasant and peaceful driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is ongoing or continuous these tips will help.

Water Damage

If you accidentally drop your key fob in a puddle, or if it is soaked while kayaking, canoeing, rafting or canyoning it is likely to be damaged by water. Keep your key fob in a dry, dry bag each time you are outdoors or engage in things that expose it to large amounts of water.

It's also essential to make sure the fob has completely dried out before you open it up and then use it again. If you smell any odors emanating from the fob (such as industrial liquid or windshield washer fluid) It's another indicator that it is submerged.

A wet circuit can cause the battery's energy to drain or even explode. If you can remove your keyfob 308 out of the water you need to turn the button side up and shake as much water out as possible before opening the casing. Once you have opened it, remove the battery and wipe the circuit board with an abrasive soaked in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not function could be due to a dead coin-cell battery or receiver module issue signal interference or a malfunctioning chip. If none of these is the issue, try resetting the system by removing the battery that is 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start technology that allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the car before entering. This feature is very beneficial, especially in the cold winter months. The remote start system may be stopped for a variety of reasons, including the dead battery in the coin-battery.

The coin-shaped battery inside the key fob will last between two and four years, based on the frequency with which it is used, where it was purchased, and the way it is used. The date for use-by is typically written on the package or marked in the manual.

If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, clean the chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it may have caused the chip to become damaged. You'll need to replace it.

If you're unsure if the battery is defective, you can test the voltage with an instrument set to the car's voltage range. Connect it to the plus and minus terminals. The voltage should read approximately 12-13 volts, however, if it reads lower, the battery must be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start.

Faulty Receiver Module

If you don't see "Key Detected", it could be that your receiver module is not working properly. It's the part that transmits an alert when your key fob activates. It also functions as an alarm, and stops the car from starting if it doesn't have the correct key.

The cause could be a number of causes, such as water damage or simply getting old. If your Peugeot 308 key fob has been exposed dirty tap water, for example the electronic chip inside the device will be damaged. In this scenario you'll need to remove the device apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. Once it's dry you can put the battery back into the battery and try again.

If the problem persists you're probably in need of a idea to seek out a local Peugeot specialist or locksmith. They'll be able use a diagnostic tool to identify the problem and fix it.

The loss of your Peugeot car keys could be an extremely stressful experience. A reputable auto locksmith will be able to solve the issue in a matter of minutes. They can program your car and cut a new working key for you. Click here to locate a locksmith near you.

Electronic chip malfunctions

The electronic chip that is in the peugeot 308 key fob replacement 308 key fob is a very important part of the remote control system. If it becomes damaged, your car may not start, or you could receive a message that reads "anti-theft active". In this instance, the only solution is to replace the key. Fortunately, auto locksmiths with experience can complete the task within the shortest period of time.

The chip inside your Peugeot 308's key fob could be damaged due to a variety of reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed dirty or soapy water, it must be cleaned as soon as possible. You can clean the electronic component using a paper towel soaked in isopropyl Alcohol. The battery should then be allowed to dry completely.

Radio interference can cause the key fob to stop functioning. This can happen when other devices use the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects in the vicinity of the vehicle. If you experience this issue, it is best to visit a Peugeot dealership.

The Peugeot 207/308 key fob is very delicate and requires a lot of attention. It is not recommended to drop it or throw it around. If you lose it, try to locate it as quickly as is possible. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Remove the negative cable before the positive.